White-rodgers 1F83-71 Manuel d'utilisateur télécharger pdf

Printed in U.S.A.

DESCRIPTION

1F83-71

Non-Programmable Electronic

Digital Automatic Changeover Multi-stage Thermostat

INSTALLATION AND

OPERATION INSTRUCTIONS

PART NO. 37-6126B

Replaces 37-6126A

0004

Operator: Save these instructions for future use!

FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY

BEFORE INSTALLING OR OPERATING THIS CONTROL COULD CAUSE

PERSONAL INJURY AND/OR PROPERTY DAMAGE.

PRECAUTIONS

SPECIFICATIONS

CAUTION

WARNING

WHITE-RODGERS DIVISION

EMERSON ELECTRIC CO.

9797 REAVIS ROAD

ST. LOUIS, MISSOURI 63123-5398

WHITE-RODGERS

Your new White-Rodgers Digital Multi-stage Thermostat uses

the technology of a solid-state microcomputer to provide precise

time/temperature control.

Features:

• Simultaneous heat and cool setpoint storage

• Optional C terminal (dual power option)

• Optional B and O terminals

• Preprogrammed temperature control

• LCD continuously displays setpoint and room temperature

• °F/°C convertibility

• Temperature range 45° to 90°F

• Two-stage heat/two-stage cool

• Armchair programming capability

This thermostat is intended for use with a 24-volt system; do not

use this thermostat with a millivolt or line voltage system. If in

doubt about whether your wiring is millivolt, line, or low voltage,

have it inspected by a qualified heating and air conditioning

contractor or electrician.

Do not exceed the specification ratings.

All wiring must conform to local and national electrical codes and

ordinances.

This control is a precision instrument, and should be handled

carefully. Rough handling or distorting components could cause

the control to malfunction.

To prevent electrical shock and/or equipment damage

disconnect electric power to system at main fuse or

circuit breaker box until installation is complete.

Do not use on circuits exceeding specified voltage.

Higher voltage will damage control and could cause

shock or fire hazard.

Do not short out terminals on gas valve or primary

control to test. Short or incorrect wiring will damage

thermostat and could cause personal injury and/or

property damage.

ELECTRICAL DATA

Electrical Rating:

20 to 30 VAC 50/60 Hz. or D.C.

0.05 to 1.5 Amps (Load per terminal)

1.5 Amps Maximum Total Load (All terminals combined)

THERMAL DATA

Setpoint Temperature Range:

45°F to 90°F (7°C to 32°C)

Operating Ambient Temperature Range:

32°F to 105°F

Operating Humidity Range:

0 to 90% RH (non-condensing)

Shipping Temperature Range:

-40°F to 150°F

APPLICATIONS

For use with:

• Heat/cool systems with up to two stages heat, two

stages cool

DO NOT USE WITH:

• Millivolt systems

• Systems exceeding 30 VAC and 2.5 amps

• 3-wire zoned hydronic heating systems

1 2 3 4 5 6

Résumé du contenu

Page 1 - WHITE-RODGERS

Printed in U.S.A.DESCRIPTION1F83-71Non-Programmable ElectronicDigital Automatic Changeover Multi-stage ThermostatINSTALLATION ANDOPERATION INSTRUCTION

Page 2 - INSTALLATION

2REMOVE OLD THERMOSTAT1. Shut off electricity at the main fuse box until installation iscomplete. Ensure that electrical power is disconnected.2. Remo

Page 3 - NOTENOTE

3NOTENOTEThe following wiring diagrams show typical terminal identifica-tion and wiring. For proper installation, refer to the originalmanufacturer’s

Page 4 - Cooling System

4Heating System1. Press SYSTEM button to turn thermostat to HEAT.2. Press to adjust thermostat setting to 90° and hold for fiveseconds. After you re

Page 5 - TROUBLESHOOTING

5OPERATIONFigure 6. Thermostat display, buttons, and switchesCL 1+2OFFHT 1+25576 8213 4LOCKCOOL-OFF-HEAT-AUTOAUTOFAN ONSYSTEM9BATTERYBefore you begin

Page 6

Commentaires sur ces manuels

Pas de commentaire

White-rodgers 1F83-71 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Panneau de contrôle White-rodgers 1F83-71. White Rodgers 1F83-71 User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Panneau de contrôle White-rodgers 1F83-71