White Rodgers 30A46-105 Manuel d'installation

Naviguer en ligne ou télécharger Manuel d'installation pour Non White Rodgers 30A46-105. White Rodgers 30A46-105 Installation Instructions Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 6
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
WHITE-RODGERS DIVISION
EMERSON ELECTRIC CO.
9797 REAVIS RD., ST. LOUIS, MO. 63123
(314) 577-1300, Fax (314) 577-1517
9999 HWY. 48, MARKHAM, ONT. L3P 3J3
(905) 475-4653, FAX (905) 475-4625
30A46
PLUG-IN AUTOMATIC PILOT
INSTALLATION INSTRUCTIONS
PRECAUTIONS
If in doubt about whether your wiring is millivolt, line, or low
voltage, have it inspected by a qualified heating and air condi-
tioning contractor, electrician, or someone familiar with basic
electricity and wiring.
Do not exceed the specification ratings.
All wiring must conform to local and national electrical codes and
ordinances.
This control is a precision instrument, and should be handled
carefully. Rough handling or distorting components could cause
the control to malfunction.
To prevent electrical shock and/or equipment damage,
disconnect electric power to system at main fuse or
circuit breaker box until installation is complete.
Printed in U.S.A.
PART NO. 37-5551B
Replaces 37-5551A
9623
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY
BEFORE INSTALLING OR OPERATING THIS CONTROL COULD CAUSE
PERSONAL INJURY AND/OR PROPERTY DAMAGE.
DESCRIPTION
These automatic pilots are designed for use with the White-
Rodgers gas valves having plug-in receptacle. The pilots are
simply plugged in with no additional electrical connections or
mounting devices required.
When used with these valves, they prevent the flow of gas to the
main burner if the pilot flame is not burning or is insufficient to
properly ignite the main burner.
These plug-in pilots may be used with natural, manufactured, or
mixed gases, and with L.P. gases where means are provided for
obtaining a 100% shutoff system. The pilot burner should be
equipped with the recommended size orifice fitting.
These pilots are automatic reset (automatic recycling) needing
merely relighting or possibly only the resumption of proper gas
pressure to put back in operation.
ATTENTION!
This product contains mercury. There will not be any exposure to mercury under normal conditions of use. This product may
replace a unit which contains mercury. Do not open mercury cells. If a cell becomes damaged, do not touch any spilled
mercury. Wearing non-absorbent gloves, take up the spilled mercury with sand or other absorbent material and place into a
container which can be sealed. If a cell becomes damaged, the unit should be discarded. Mercury must not be discarded in
household trash. When this unit or the unit it is replacing is to be discarded, place in a suitable container and return to us .
Shut off main gas to heating system until installation is
complete.
Label all wires prior to disconnection when servicing
controls. Wiring errors can cause improper and dan-
gerous operation.
Following installation or replacement, follow appliance
manufacturer's recommended installation and/or ser-
vice instructions to insure proper operation.
Operator: Save these instructions for future use!
WHITE-RODGERS
WARNING
!
CAUTION
!
Vue de la page 0
1 2 3 4 5 6

Résumé du contenu

Page 1 - WHITE-RODGERS

WHITE-RODGERS DIVISIONEMERSON ELECTRIC CO.9797 REAVIS RD., ST. LOUIS, MO. 63123(314) 577-1300, Fax (314) 577-15179999 HWY. 48, MARKHAM, ONT. L3P 3J3

Page 2 - INSTALLATION

2These Pilots can be used with either A, B, or E series pilotburners.Pilot Burners are available in 14 port arrangements, Bunsenand “Non-linting”, and

Page 3 - TESTING THE PILOT

3The following procedure should be closely followed when light-ing the Automatic Pilot:1. Set the room thermostat to the lowest setting on the dial.2.

Page 4

WHITE-RODGERS DIVISIONEMERSON ELECTRIC CO.9797 REAVIS RD., ST. LOUIS, MO. 63123(314) 577-1300, Télécopieur (314) 577-15179999 HWY. 48, MARKHAM, ONT.

Page 5 - SPÉCIFICATIONS

2SPÉCIFICATIONSINSTALLATIONCes veilleuses peuvent servir avec les brûleurs de veilleusedes séries A, B et E.Les brûleurs de veilleuse sont disponibles

Page 6 - VÉRIFICATION DE LA VEILLEUSE

3ALLUMAGE DE LA VEILLEUSEVÉRIFICATION DE LA VEILLEUSEPour allumer la veilleuse automatique, suivez exactement ladémarche suivante :1. Réglez le thermo

Commentaires sur ces manuels

Pas de commentaire