White-rodgers 1E65-144 Manuel d'utilisateur télécharger pdf

PART NO. 37-6862D

Replaces 37-6862C

0839

1E65-144

Non-programmable Electronic Digital Thermostat

For Line Voltage Applications

INSTALLATION AND OPERATION INSTRUCTIONS

Operator: Save these instructions for future use!

DESCRIPTION

White-Rodgers is a division

of Emerson Electric Co.

www.white-rodgers.com

The 1E65-144 thermostat has been designed to control electric heating

systems such as baseboard heaters, radiant ﬂ oors, radiant ceilings

and convectors.

The adapter plate is used to offset the thermostat when an obstruction

prevents the thermostat from being mounted directly to the junction

box.

The thermostat cannot be used with the following:

- a resistive load under 2 A

- a resistive load over 16.7 A

- systems driven by a contactor or a relay (inductive load)

- central heating systems

Parts Supplied: Available Accessories:

One (1) thermostat F61-2642 Adapter Plate

Two (2) 6-32 pan head screws

Supply: 120/240 VAC, 50/60 Hz

Minimum load: 2 A (resistive only)

500 W @ 240 VAC

250 W @ 120 VAC

Maximum load: 16.7 A (resistive only)

4000 W @ 240 VAC

2000 W @ 120 VAC

Setpoint range: 7°C to 32°C (45°F to 90°F)

Display range: 0°C to 37°C (32°F to 99°F)

Display resolution: 0.1°C (1°F)

Shipping: –20°C to 50°C (-4°F to 120°F)

Approval:

INSTALLATION

Installation should be done by a qualiﬁ ed heating and air conditioning

contractor or licensed electrician.

Loosen the screw holding the thermostat cover to the base, open cover

on hinge and remove the cover.

Temperature

Display

Temperature

Adjustment

Buttons

Light

Button

System

Switch

PRECAUTIONS

* Failure to read and follow all instructions carefully before

installing or operating this control could cause personal injury

and/or property damage.

* All wiring must conform to local and national electrical

codes and ordinances.

WARNING

* To prevent electrical shock, personal injury, and/or equipment

damage, disconnect electric power to system at main fuse or

circuit breaker box prior to installation or service.

Screw

SPECIFICATIONS

Optional: Use the adapter plate accessory if you need to offset the

mounting holes on the junction box. Align and afﬁ x the wall plate to

the electrical junction box using two 6-32 ﬂ at head screws included

with the plate.

1 2 3 4

Résumé du contenu

Page 1 - 1E65-144

PART NO. 37-6862DReplaces 37-6862C08391E65-144Non-programmable Electronic Digital Thermostat For Line Voltage ApplicationsINSTALLATION AND OPERATION I

Page 2 - INSTALLATION (cont.)

Make the appropriate connections to the thermostat as per diagram below. The wires are non-polarized so either wire can be connected to either termina

Page 3

1E65-144Thermostat numérique électronique non programmable pour installations à la tension du réseauPIÈCE No 37-6862DRemplace 37-6862C0839DIRECTIVES D

Page 4 - ATTENTION

Le logo Emerson est une marque de commerce et de service d’Emerson Electric Co.Câbler le thermostat en suivant le schéma ci-dessous. Les ﬁ ls ne sont